Forum

Changing grips
 
Notifications
Clear all

Changing grips

6 Posts
4 Users
0 Likes
3,660 Views
Posts: 5
Topic starter
(@tidzyboo)
Active Member
Joined: 5 years ago

I've searched all over but can't seem to find any tutorials (in English) on how to change the grips on the TC?  I see that lots of people have done this mod,  when I attempt to unscrew the Allen key at the bar end it seems like it might just be spinning there. Furthermore it's cheap plastic so I don't want stress it too much and compound the task.   Can anyone offer some insight please? 

 

thanks!

5 Replies
Posts: 177
(@flyingelectric)
Estimable Member
Joined: 5 years ago

Hi tidy.

You buy motorcycle or moped grips that you want.

Then you remove left side first to se how it goes and how easy / hard it is. Then you need to be more gentle with the right side which is also the gas/throttle side as we don't want to impair and damage it. Same when putting the  new ones on. How I did it on the throttle side was to remove and destroy the old outside rubber on the grip so that only the plastic part was still left on the handlebar. The left side I just pulled out much easier.

To remove a grip you may need some kind of flat tool and oil/ alcohol or soap to make it easier to remove or put on. Maybe there are videos on youtube how to do it.

Good luck

 

Reply
Posts: 5
Topic starter
(@tidzyboo)
Active Member
Joined: 5 years ago

thanks for the reply, I managed to do it by carefully cutting off the grips with a razor.  New Grips and bar are much better.

Reply
Posts: 33
(@paris123)
Eminent Member
Joined: 5 years ago

Please make a tutorial

Reply
1 Reply
(@tidzyboo)
Joined: 5 years ago

Active Member
Posts: 5

@paris123

sorry, too late now. no pics!

Reply
Posts: 53
(@phil-de-canillas)
Trusted Member
Joined: 5 years ago

Sorry, no pics but:

Use a sharp craft knife and slice off both bar ends.

Next make a longitudinal slice right through the grips, the left grip should peel off easily.

With the right grip you will need to use the knife to separate the glued grip from the plastic accelerator sleeve beneath, takes less than 5 minutes.

Make sure that you thoroughly clean the throttle tube of all the glue before you fit the new one; my new grips are so tight that I used soap to ease them on, glue not needed.

Have fun.  😉

Reply