hello.This morning my super soco with a battery charged with 90% stopped suddenly when it was running at 45 km after 3 km.the screen also.I do not start. After removing the battery cable and hitting the disconnector repeatedly connect. someone happened to him?
hello.This morning my super soco with a battery charged with 90% stopped suddenly when it was running at 45 km after 3 km.the screen also.I do not start. After removing the battery cable and hitting the disconnector repeatedly connect. someone happened to him?
This sounds like a battery/battery plug or connector issue. Maybe a loose connector, I would contact your dealer...
Did the screen flashing too? or it just died?
another failure last night back home the battery to 6% and the motorcycle was more and more slowly. At the end it stopped and came out 98 and danger stopping
If I remember correctly mine also has a 98 while flashing the warning symbol. This is when my battery turns off and stops providing power to accelerate and you see the bar to the the bottom even if on full throttle. Luckily if my bike is going fast enough the electricity generated from the spinning wheels actually provide enough power to keep the headlights, screen and indicator on for me however if I am too slow while the incident happens and it doesn’t product enough power before the battery starts to kick in again, the bike turns off and requires the key fob to be pressed to unlock and restart and this is when the danger really starts. I found out that the wheels on the Super Soco like car wheels are also used to slightly provide more power to the battery from the generated electricity by unplugging the battery about 30 mph on a big open road and the bike actually stayed for a long period of time
3 days if I fail again of the general strike .... I will continue observing. Last night may be less than 6% load ?. Very strange. At the next fault I will call the distributor.
It’s the heat that hits you... you get fault code 98:”controller pauses operation(possible overcurrent, blocking, under pressure, overheating)”
So somewhere in the system there is creating so much heat that the controller is gone for a few minutes.
I also had this one time. But I rode from 100% to 2% and he began to stop working.
