Forum

@totofaki perfect thanks, il order one up and give it a try 👍 ah ok so seems you had power flowing back into the battery at some point then? That’s ...

@totofaki I have the second gen 2019 model. Not sure if they changed accel smoothness from the first gen or not, Iv heard 2020 is a fair improvement. ...

@totofaki ah ok thanks for the info. Yeah would definitely be interesting to see how the bike would get on with a larger controller. Interesting to ...

@rodrigoono You can activate the charger via the pin circled in the photo. Once it’s been activated the pin is no longer needed and the charger r...

@totofaki ah yes good call 👌 Did you mod the battery at all as it’s limited to 60a or 80a depending on model. Would have thought the battery is more...

@totofaki brilliant thanks. Where does the speed signal come from for the speedo as the hall sensors from the motor are now connected to the new spe...

@totofaki Interested to know about you fitting a Kelly controller to your Tc max. You connect in replacement of your original controller? Wondering ...

@soulhunter hmmm yeah I see what you mean, I will check mine and see if the cable thickness difference is the same as yours. Il let you know what I ...

@camperman63 no not tricky, it was awhile ago I did it. I think it was probably a small flathead to prise it open. It’ll be fairly straight forward on...

@soulhunter there’s only two power cables, the rest are purely data cables and carry very little current. Your black and red power cables only need to...

@camperman63 yeah remove the screw and the switch drops down. The plastic housing needs to be prised apart (you can see the join) and will need to be ...

@camperman63 the problem is most likely internal to the switch itself. Remove it, open it up carefully and clean the contacts. Apply some dielectric g...

@theswede seems like maybe your only removing the one side panel. All the plastic trim can be removed to eventually just the frame. It’s a bit of a ...

Run your motor with the rear wheel in the air. Give the brake a squeeze and if the motor cuts out then atleast that will confirm your switches arnt at...

The orange cable is just secured with zip ties under the trim. Take some panels off till you can see the ties and move the orange cable out a bit.