Last seen: 25/04/2024 10:55
Mines alloy and tubless which like a car, the valve stem is an airtight seal into the rim. On my old BSA with spokes, the valve stem is part of the in...
Posted images in the past, but didn't work this time, only the file. web-TCmax-charger-rap.jpg
Hi, The STD charger with UK three pin 220v plug, tight fit in the trunk, but it's a tight rap. TCmax-charger-rap.jpg
I looks to me that the rear wheel is out of alignment. Support the bike so that the wheel is off the ground and free to rotate. Slacken the wheel ...
With upside down forks one usually needs to remove the leg so as to tip the oil out which may be a little tricky, I've not done it. The quantity recor...
mjr, Regarding fewer things to check, my TCmax was the first EV they had tested, they are a well established bike shop been going for years. They se...
For future ref' if the pads are stopping the disk entering between them, use a soft tool like a plastic freezer ice scrapper and lever the pads back, ...
Generally to bleed a hydraulic system you fit a flexible tube over the bleed nipple on the caliper and submerge the other end of the tube into a jar w...
All done, no problems 😀
If you are not the first owner and it's a TCmax then the first owner has to un-bind before anyone else can bind. That's all I know.
I had to translate what Michi said, but can'i help. 😎 Hello I'm new here I have a problem with my super so o ts BJ,,2019 unfortunately there is no ...
@docweyr See if this video works, After a lot of trying I can get my charger in and close the lid. Charger-cabling.MOV