Last seen: 10/06/2024 15:50
@petesscalefabshop in you opinion the efficiency is better than VEC300?
@petesscalefabshop how are you with Fardriver controller?
@petesscalefabshop did you understand what is "Speed Parameter settings" and how does it work? VEC300.jpg
@petesscalefabshop Good, this is a parameter that I didn't tested. In my last configuration I lowered the start up phase current and I enabled the boo...
@petesscalefabshop Why do you set max rpm to 9.000?
Buy the cheapest ust-ttl adapter and connect it as shown in the diagram attached. I shared also the programming software. VEC300-cont...
@petesscalefabshop I can try to play with rpm and see if make the difference. I have also another problem, on full throttle after 30 seconds shows e...
@petesscalefabshop solved, it was wiring connectio. I also tested your settings. I like very much the resoult but I only found a problem with throttle...
@petesscalefabshop I can read my parameters but I can't write them, when I press upload old parameter come back. Did you had the same issue?
@petesscalefabshop ok, because you bypassed bms in discharge.
@petesscalefabshop Why you didn't use the power cable also to charge battery?
Why I can't see your pictures?