Last seen: 13/05/2024 21:00
@petesscalefabshop in you opinion the efficiency is better than VEC300?
@petesscalefabshop how are you with Fardriver controller?
@petesscalefabshop did you understand what is "Speed Parameter settings" and how does it work? VEC300.jpg
@petesscalefabshop Good, this is a parameter that I didn't tested. In my last configuration I lowered the start up phase current and I enabled the boo...
@petesscalefabshop Why do you set max rpm to 9.000?
Buy the cheapest ust-ttl adapter and connect it as shown in the diagram attached. I shared also the programming software. VEC300-cont...
@petesscalefabshop I can try to play with rpm and see if make the difference. I have also another problem, on full throttle after 30 seconds shows e...
@petesscalefabshop solved, it was wiring connectio. I also tested your settings. I like very much the resoult but I only found a problem with throttle...
@petesscalefabshop I can read my parameters but I can't write them, when I press upload old parameter come back. Did you had the same issue?
@petesscalefabshop ok, because you bypassed bms in discharge.
@petesscalefabshop Why you didn't use the power cable also to charge battery?
Why I can't see your pictures?
After disconnecting and reconnecting the balance connector the bike is dead, anybody know the reset procedure for the original c4s9cpsa14 bms? Cells a...
How do you solved the problem?